Embedded Files
Let's Meet @ an Industry Event:
Temperature Control Accessory
Temperature Control Accessory
A rendering of the temperature-controlled cuvette holder
What is the Temperature Control Accessory?
What is the Temperature Control Accessory?
The Temperature Control Accessory is an addition to the Open Platform System (OPS) from Wilson Analytical. By simply screwing the device into the unused fourth port of the cuvette holder, the temperature of the cuvette holder can be controlled by an external liquid cooling or heating loop. The sample in the cuvette quickly reaches the same temperature due to the thermal contact with the cuvette holder, enabling analysis requiring both fixed and changing temperatures.
What can it do?
What can it do?
Extend the capabilities of your Wilson Analytical OPS
Control sample temperature with heating or cooling
Optional insulating sleeve with dry gas purge supports extended temperature range
Compatible with any circulating chiller or heater; Wilson tested models available
Sample temperature within 1 °C of target in 10 minutes
Typical sample temperature curve after placement of a cuvette in a cooled or heated holder. Tested at an ambient temperature of 18°C.
Solid Sampler
Solid Sampler
The Solid Sampler is based on a rotating stage, which allows the user to test solids and liquids at various angles between the light source, sample and spectrometer.
Interlocked lid with filter holders improves safety and sensitivity.
13 mm cut solids, pressed powder pellets or microscope slides can be run.
Two types of cuvette holders are also available: an “offset” cuvette holder for measurements directly off of the surface of a sample in the cuvette or a “centered” cuvette holder for regular solution analyses.
Solid Sampler with “centered” and “offset” cuvette holders
Solid Sampler with pressed pellet
Page updated
Report abuse